Pegasi Wiki

This wiki acts as a memo for our own work so why not share them? Feel free to browse and use out notes and leave a note while at it.

Gluster FS server

Making a redundant, replicated 2 node Gluster service

  • Check that every brick in the Gluster structure has same data in hosts file or they resolv correctly from your DNS.
  • Allow traffic between bricks and from bricks to clients, at least ports tcp: 24007:24047 111 38465:38467 and udp: 111
  • Install packages and fire up Gluster in both servers / bricks
yum install fuse fuse-libs glusterfs glusterfs-server glusterfs-fuse glusterfs-geo-replication
chkconfig glusterd on; service glusterd start
gluster peer probe <other node ip>
gluster peer status
  • You should see information about the other peer(s), check both bricks
  • Make and mount the volume (remember fstab) to use for sharing, can make many logical volumes or a single one, can make several Gluster volumes inside a logical volume to share same capacity
lvcreate -L1000G -n Glustervol1 VolGroup00
mkdir /mnt/gluster
mount /dev/mapper/VolGroup00-Glustervol1 /mnt/gluster
mkdir /mnt/gluster/vol1
mkdir /mnt/gluster/vol2
gluster volume create volume1 replica 2 transport tcp <1st brick ip>:/mnt/gluster/vol1/ <2nd brick up>:/mnt/gluster/vol1/
gluster volume create volume2 replica 2 transport tcp <1st brick ip>:/mnt/gluster/vol2/ <2nd brick up>:/mnt/gluster/vol2/
# gluster volume set volume1 auth.allow 10.*
# gluster volume set volume2 auth.allow 10.*
gluster volume start vol1
gluster volume start vol2
gluster volume info vol1
gluster volume info vol2

Gluster native client

Assuming we use only ethernet for accessing.

yum install glusterfs glusterfs-fuse glusterfs
modprobe fuse
dmesg | grep -i fuse
  • There was some speculation that you should disable transparent hugepages to make Gluster work more stable but most likely this should be ignored. But just in case:
echo never > /sys/kernel/mm/redhat_transparent_hugepage/enabled
  • Put the mount straightforward to /etc/fstab. Use _netdev to make the mount come later in startup and never use the IP address of localhost, even if you have server and client on same server. The startup may not be finished by the time you get to mounting. Fstab entry:
<brick ip>:/vol1  /home/directory  glusterfs  defaults,_netdev  0 0

Leave a comment

Enter your comment:
S E Y V M
 

  //check if we are running within the DokuWiki environment if (!defined("DOKU_INC")){ die(); } //place the needed HTML source codes BELOW this line